Impianto di trivellazione orizzontale Nodigmarket24 controlled mole 50m UM-20 nuovo
Interessa l'annuncio?
1/19
28.000 €
Marca:
Nodigmarket24
Modello:
controlled mole 50m UM-20
Tipo:
impianto di trivellazione orizzontale
Ubicazione:
Polonia Zabrze
Data d'inserzione:
più di un mese
Machineryline ID:
RJ18321
Stato
Stato:
nuovo
L'ispezione a distanza
Richiedete una valutazione tecnica indipendente
Serve la consegna?
Calcolare il costo della consegna
Importante
Questa offerta è indicativa. Le informazioni esatte sono da richiedere al venditore
Consigli per l'acquisto
Dati di contatto del venditore
"NODIGMARKET24"
In vendita:
15 annunci
5 anni su Machineryline
5.0
25 recensioni
I numeri di telefono sono stati controllati
The machines are produced with various hydraulic parameters. The example machine in the pictures has a tensile force of 200kN (20t) and allows pulling PE pipes up to 200mm.
The maximum length of the jacking is 60m. It also enables cracking on small asbestos, cast iron and stoneware pipes.
Execution of the controlled squeeze takes place at the execution of a small excavation, rough setting of the machine, arming the warhead with a radio probe and pilot drilling. Then, mount the expanding head depending on the diameter of the installed pipe and pull it into the ground. The whole process is done dry. Drilling polymers are used to retract the pipe over a longer distance. giving a significant slip and reducing friction when pulling.
If you have questions or interest, please contact us via the form or by phone.
Eng. Damian Sobczak
Specialist in the construction of culverts and mechatronics
Maszyny są produkowane z różnymi parametrami hydraulicznymi. Przykładowa maszyna na zdjęciach ma siłę uciągu 200kN
i umożliwia wciąganie rur PE w zakresie średnic 32-160mm.
W komplecie 30m żerdzi, agregat, głowice i uchwyty do rur.
Maksymalna długość wykonania przecisku to 50-60m. Umożliwia również wykonanie krakingu na rurach azbestowych, żeliwnych, kamionkowych oraz PVC polietylenowych.
Wykonanie przecisku sterowanego, odbywa się na wykonaniu niewielkiego wykopu, zgrubnym ustawieniu maszyny, uzbrojeniu głowicy w sondę i wykonanie przewiertu pilotażowego. Następnie zamontowaniu głowicy poszerzającej w zależności od średnicy instalowanej rury oraz wciągnięcie jej w grunt. Cały proces odbywa się na sucho. Do wciąganie rury na dłuższym odcinku stosowane są polimery wiertnicze. dające znaczny poślizg i zmniejszenie tarcia podczas wciągania.
W razie pytań lub zainteresowania proszę kontaktować się poprzez formularz lub telefonicznie.
inż. Damian Sobczak
Specjalista d/s budowy przepustów i mechatroniki